Specifications

Falcon II Outdoor series printers – Maintenance Manual
317
AP-74065, Rev. 1.0, 21/11/03
(6) Check the head
assembly for
breakage.
• Replace the
damaged head
assembly
→ Replacing the
print head assembly
and head tape
power cable.
(7) The CR board
assembly may have
a problem.
• Replace the CR
board assembly.
→ Replacing the CR
board assembly
(8) The Mainboard
assembly may have
a problem.
• Replace the
Mainboard
assembly
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly
13 There are many satellite
droplets (unnecessary dots)
(1) Check if the use
conditions are within
the normal
operation
conditions.
• Be sure to use the
product under the
guaranteed
operation
conditions.
14 Fiber tracking is shown in prints. (2) Check if printing
began immediately
after ink
replenishment.
• The following
phenomea may
occur for the first
printing processed
immediately after
ink replenishment.
• Faint lines are
drawn.
• White streaks
appear on the
printing.
• If these conditions
are observed,
perform cleaning a
couple of times
before printing, then
check the results.
• If cleaning does
not improve the
results, leave the
products for at least
several hours, redo
the cleaning
operation, then
check the results
again.
→ User’s Guide
15 Lines look blurred when printed. (3) Check if the
tension of the steel
belt is properly
adjusted.
• Adjust the steel
belt tension.
→ Steel belt tension
adjustment
(4) Check the head
adjustments.
• Adjust the head.
→ Head precision
adjustment