Specifications

Falcon II Outdoor series printers – Maintenance Manual
332
AP-74065, Rev. 1.0, 21/11/03
(3) Check the
“Encoder:PF” via
“Test:Encoder” of
the self-diagnostic
function
• Make sure that the
connections of
Mainboard
assembly connector
J132 are good.
• Replace the T
fence.
• Replace the
CR_ENC assembly.
• Replace the CR
motor.
• Replace the
CR_BASE board
assembly.
• Replace the CR
tape power cables.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly→
Replacing the T
fence.
→ Replacing the CR
motor assembly
→ Replacing the CR
board assembly.
→ Replacing
(storing) the steel
bearing, tube guide,
CR tape power
cable and ink tube.
(4) The Mainboard
assembly may have
a problem.
• Replace the
Mainboard
assembly
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly
(1) The program
ROM may have
failed.
• Upgrade he
firmware version.
→ Firmware
installation
9 After printing has been
completed, the paper is fed an
extra amount.
(2) The Mainboard
assembly may have
a problem.
• Replace the
Mainboard
assembly
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly