Instruction manual

Operation Instructions Rockhopper 3 Extreme
CHAPTER 4 : PERIODICAL MAINTENANCE
31
AP-77150 – Rev. 2.0
4.1.1.2 Cleaning around the bottom of heads
Step 1 : Open the left maintenance covers by removing the four screws.
Step 2 : Power ON the printer and go to the “WiperClean-Menu” DON’T press enter when in it.
This will cause the unlocking of the carriage.
Step 3 : Slide the carriage into the left maintenance area.
Step 4 : Clean the edges of the heads with a swab (1) wetted by eco solvent cleaning as shown on the
image below.
Caution
• Make sure not to touch the nozzle plate. This could lead to poorer print quality.
•
It is recommended to wear gloves (2) as shown on the picture below.
Step 5 : Press the [ENTER] key in the active display (=WiperClean menu)
The head will cap in and be locked.