User guide

Setting up the cutter Operation Instructions SC Cutting Plotters
Page
1
AP-75026 Rev 1.0 - 11/01/00
SETTING UP THE CUTTER
PREPARING THE CUTTING ENVIRONMENT
The location where you set up your equipment is very important. Please see to it that it
meets following conditions :
♦
Power supply of 100 to 120 VAC 50/60 Hz or 200 to 240 VAC 50/60 Hz.
♦
Ambient Conditions :
•
Operating environment
- Temperature : 5° C to 40° C ( 41° F to 104° F )
- Humidity : 35% - 75% non-condensing.
•
Recommended environment
- Temperature : Room temperature 16°C to 32°C ( 61° F to 90° F )
- Humidity : 50% to 65%, non-condensing.
•
Variation rate
- Temperature : 2° C per hour.
- Humidity : 5% per hour.
•
Storage environment
- Temperature : 0° C to 50° C ( 32° F to 122° F)
♦
Please protect your cutter from moisture, dust, draughts and direct sunlight. It is
best to keep your machine away from open windows and air-conditioners.
♦
See to it that there is an adequate space around the cutter so that ventilation is
not obstructed.
♦
Avoid unnecessary vibrations and set up your cutter on a level surface.
When selecting a place for your cutter, leave at least 90 cm in front and 90 cm at
the rear, as shown in the illustration below.