User`s guide

User’s Guide ValueJet 1204

Chapter 3: Installing the Unit

41 AP-75740 – Rev 1.2 – 6/07/2011

3.8 TRANSFER AND TRANSPORTATION

Caution

• Transfer the printer maintaining the horizontal position.

• Do not place the printer on a slope or vertical position, nor keep the printer upside down. This

to avoid ink leaks inside the printer. Moreover, normal operation after shifting to these

positions cannot be guaranteed.

Step 1 Verify that the printer is powered ON.

Step 2 Pull out the waste fluid tank.

N° Description

Waste fluid box

Result: the operation panel displays “No Waste fluid box".

Notes

• A used waste fluid tank must be put in a vinyl bag or a bag used for this kind of waste.

• Disposal of a waste fluid tank must be done according to your local laws and regulations.

Step 3 Install a new waste fluid tank.

N° Description

Waste fluid box

Step 4 Verify that the operation panel displays "Exchange Tank? No".

Step 5 Select "Exchange Tank? Yes” and press the [Enter] key.

Step 6 Remove all ink cassettes

Step 7 Switch OFF the printer.

• The operation panel displays “Transport Mode”, and the printer starts the ink rejecting operation. This

takes approximately 2 minutes.