User`s guide

User’s Guide ValueJet 1204
Chapter 4: Handling the printer
52 AP-75740 – Rev 1.2 – 6/07/2011
4.4 HANDLING AND INSTALLING MEDIA
Notes
• Refer to “General info on usable media” for details on media handling.
• It is recommended to use tested and compatible media for this printer.
4.4.1 Installing roll media
Notes
• Only use the scroller supplied with this printer.
• For media with a three inch core, three-inch core adapters must be used.
Notes
• It is possible to load the following roll media on the printer’s scroller :
o two inches diameter media core (outer diameter less than 150 mm, weight 19kg or less)
o three inches diameter media core (outer diameter less than 150 mm, weight 19kg or less)
• For details, refer to: “Product specifications”.
Notes
• Set the roll media on a flat and levelled surface.
• If the roll media and scroller are placed in a vertical position, the scroller might get damaged.
Notes
• If you use an optional Take-Up system, please refer to the user guide of the ValueJet 1204 Take-
Up system.
Step 1 : Remove the movable flange from the scroller.
Step 2 : Install the optional three-inch core adapters :
• If using media on a 2 inch core: Don’t use the three-inch core adapters, go to step 3.
• If using media on a 3 inch core: Click a three-inch core adapter on the fixed flange and the
movable flange.
N° Name
1 Movable flange
2 Fixed flange
3 Three-inch core adapter