User`s guide

User’s Guide ValueJet 1204
Chapter 4: Handling the printer
65 AP-75740 – Rev 1.2 – 6/07/2011
Step 9 : Set up the Micro Adjustment Change.
• Press the [+] or [–] key to select "PF5: Micro Adj.Change".
• Press the [Enter] key.
o The operation panel displays "Micro: 0pulse".
• Press the [+] or [–] key and enter the micro adjustment value according to the printing result
in step 7.
• Press the [Enter] key.
o The micro adjustment value is saved.
o The operation panel displays "PF5: Micro Adj.Change".
o The Media feed compensation is complete.
4.4.6 Replacing roll media
Describes the replacement time and replacement method for roll media.
(1) Replacement time
Replace roll media if...
…the roll media runs out.
• The operation panel displays "End of Roll".
• If the media runs out during printing, the printer stops printing.
…you want to change the media type.
(2) Replacement steps
Caution
• Be careful not to pinch your fingers when opening or closing the front cover.
1. Remove the installed roll media.
Step 1 : Verify that
• the printer is switched ON,
• the printer is in Normal mode, and
• the printer is NOT printing
Step 2 : Push the media hold lever backward (lever up).
N° Name
1 Media loading lever