User`s guide

User’s Guide ValueJet 1204
Chapter 4: Handling the printer
79 AP-75740 – Rev 1.2 – 6/07/2011
4.8 SETUP MENU
The complete menu structure and its function:
Setup item Description
MediaType Set up the media type for printing.
Effect Set up the Effect menu.
Flushing Set up the Flushing operation while printing.
Side Margin Set up the right and left margin when printing.
Media Initial Set up whether the media width and edge are detected when initializing the
media.
Media Width/MediaWidth Set up the media width from the loading mark to the left end if media detection
is not performed when initializing the media.
Display the detected media width if media detection is performed when
initializing the media.
Origin Set the beginning of printing (origin) of the printing data.
Prev. Stick Set up to prevent media from sticking when printing.
CR Movement Set up the range to move the print head while printing.
Overwrite Cnt Set up the Overwrite Cnt per line.
Overwrite Wait Set up the waiting time while overwrite printing.
Slant Check Set up the slanting detection while loading the media.
Auto Cleaning Set up the auto cleaning time while printing.
Ink Status Display information (ink status) of ink cassette that was installed into the ink
cassette slot.
Roll Length Set up the roll media length.
Head Wash Perform head cleaning.
CR Maintenance Clean the wiper.
Initialization The setting value of the printer is returned to default
Life Times Display the operational life time of each part.
IP Address Sets the IP address of the printer.
Subnet Mask Sets the subnet mask of the printer.
Gateway Sets the Gateway.
Temporary The settings of "Off" or "ALL Off" in the Selection menu are displayed in the
Setup menu temporary.
— [Cancel] key: Shift to the previous hierarchy.
4.8.1 MediaType menu
Set up the media type for printing.
Setup item Setting Value Description
Media Type 1 Set up the media type for printing.
It is possible to set 30 different user settings as
"Type 1-30" for printing.
Type 2
...
Type 29
Type 30
— [Cancel] key: Save the setting value and shift to
the previous hierarchy.