User`s guide

User’s Guide ValueJet 1204
Chapter 4: Handling the printer
95 AP-75740 – Rev 1.2 – 6/07/2011
4.9.3 Cutting media
Caution
• When a print is finished, wait until the media guide is cooled off before cutting. This to let the
ink dry and not to burn yourself.
Regarding the operating condition of the printer, check the following:
o Printing or other operations are not performed.
o Make sure that the display shows the normal state.
Step 1 : If the roll media cut position is changed, refer to Feeding media and advance the roll media to
the desired cut position.
Step 2 : Place a razor blade on the media cut groove on the media guide, and cut the roll media.
Caution
• When cutting media, move the razor blade along the media cut groove and be careful not to
place your finger on the media cut groove.
N° name
1 Media guide
2 Media cut groove
3 Razor blade
Result: Cutting roll media is complete.
Notes
• If the front edge of the media is not straight when loading the new roll media, cut it straight.