User`s guide

User’s Guide ValueJet 1204
Chapter 4: Handling the printer
96 AP-75740 – Rev 1.2 – 6/07/2011
4.9.4 Changing and confirming settings on the fly
While the printer is operating, you can change or confirm settings for the Panel setup menu.
4.9.4.1 Procedure
for changing and confirming set settings while printing
Step 1 : Confirm that the printer is in one of the following situations.
• Receiving
• Converting
• Printing
• Warming Up
Step 2 : Press the [Menu].
Result: The operation panel displays "Menu 1: Print Start".
Step 3 : Press the [+] or [–] key to change or confirm settings.
Notes
• For the settings which can be changed or confirmed, refer to settings that can be changed or
confirmed while printing.
4.9.4.2 settings that can be changed or confirmed while printing
Setup Item Setting Description
Print start - [Enter] key: If the heater temperature does not reach the set
value during warming-up, printing starts.
Temperature Pre Check the current Pre Heater temperature.
Fixer (platen) Check the current Fixer (Platen) temperature.
Dryer Check the current Dryer temperature.
Pre Heater Off / 30 °C to 50°C Change the Pre Heater temperature.
Fixer (Platen) Off / 30 °C to 50°C Change the fixer (platen) temperature.
Dryer Off / 30 °C to 50°C Change the dryer temperature.
PF Adjust -20 pulse to 0 to 20 pulse Change the feed adjustment value.
Backup - [Enter] key: Save the changed settings.
- [Cancel] key: The printer enters in the normal condition
Notes
• The Print start menu is displayed only when the printer is warming up.
• When you change the settings during operation, be sure to select "Backup" to save the changed
value.
If the printer returns to normal status without selecting "Backup", the changed value is not
saved.