Instruction manual

5 Troubleshooting
VJ-1204 QUICK REFERENCE
5 Troubleshooting 5-19
5.4 Error messages
This section describes messages displayed during normal printer operation or when errors occur, and
solutions to the messages.
5.4.1 Status messages
This section describes messages displayed during printer normal operation.
When the product is operating correctly, each operation status is displayed on the operation panel as
below.
No. Display Remedy Reference
1 Ready to Print Standby (Media is loaded).
—
2 Media End Standby (Media is not loaded).
3.5 Setting media
3 Receiving Receiving data.
—
4 Converting Analyzing data.
—
5 Printing Under printing.
—
6 Warming Up Warming up the heater.
—
7 Cleaning **% Cleaning the head. Please wait a while.
4.2.3 Head
cleaning
8 Ink Refill **% Filling the ink. Please wait a while.
3.4 Installing ink
cartridges
9 Washing Washing the print head by Head washing.
Please wait a while.
3.4 Installing ink
cartridges
10 Moving Origin Pos. The print head is moving to the original
printing position in the Origin setup menu.
Please wait a while.
"5 Panel setup
menu" in the
Operation Manual
11 Confirm Position – >E The print head is moving to the original
printing position in the Origin setup menu.
Press the [Enter] key.
"5 Panel setup
menu" in the
Operation Manual
12 Remove Cartridges Washing the head.
Attach the cleaning cartridge.
"5 Panel setup
menu" in the
Operation Manual
13 ** Initialing ** Initializing the setting in the Initialization
menu. Please wait a while.
"5 Panel setup
menu" in the
Operation Manual
14 ** Press 2sec. ** The [Cleaning] key or the [Nozzle Check]
key is pressed for less than 2 seconds. Press
the key for more than 2 seconds again.
2.1.3 Operation
panel
15 Insert CleaningCart. Washing the head.
Attach the cleaning cartridge.
3.4 Installing ink
cartridges
16 Insert InkCartridges Filling the ink.
Insert an ink cartridge.
3.4 Installing ink
cartridges
17 Transport Mode Preparing for transportation. Please wait a
while.
"6.3.2
Transporting the
printer" in the
Operation Manual
18 Media: Type ** OK? Initializing the media.
Please wait a while.
(** represents the setup media type.)
"3.4.4 Setting
media type" in the
Operation Manual
19 Media Initial
20 Cover Open The front cover is open.
3.5 Setting media
21 Lever Up The media loading lever was switched to the
back side. Set the media.
3.5 Setting media