User`s guide

Operation Instructions VJ-1204

AP-77170, Rev. 2.0, 2/04/2007

3.8 STEP ADJUSTMENT

After every printed swat, the media is fed a certain distance. Depending on the kind of media (weight,

backing) another media feed compensation has to be set. This to avoid the following phenomenon:

• Printed swats overlap.

• White lines between every swat.

In such cases, follow the procedure below and adjust the media feed compensation value.

Step 0 : Display the step adjustment menu on the operation panel.

Step 0 : Press the [Menu] key on the operation panel.

• Shift to the Setup menu display.

• The operation panel displays "Menu 1: Setup>".

Step 0 : Press the [>] key on the operation panel.

• The operation panel displays "Set1: MediaType".

Step 0 : Press the [Enter] key on the operation panel.

 The operation panel displays "Media: Type 1".

Step 0 : Press the [+] key or [–] key to select the media type you wish to use.

Step 0 : Press the [Enter] key on the operation panel.

• The operation panel displays "**>1: Print Mode".

Notes

• The selected media (Type 1-30) is displayed in "**". Please refer to “Media Type menu”

• Press the [+] key or [–] key to select "**>2: PF Adjust>".

• Press the [>] key on the operation panel.

o The operation panel displays "PF1: Init.Adj.Print".