User`s guide

Operation Instructions VJ-1204
46
AP-77170, Rev. 2.0, 2/04/2007
Step 7 : Perform the initial adjust print.
• Press the [Enter] key on the operation panel.
o The operation panel displays "Feed Length: 250 mm".
Notes
• The length that media is fed (feeding length) for initial adjustment printing is normally set at 250 mm.
• If you make the feeding length longer, the accuracy of the Media feed compensation improves.
If you want to change the feeding length, press the [+] key or [–] key and change the set value.
• Press the [Enter] key on the operation panel.
o The operation panel displays "Printing".
o Start Initial adjustment printing.
2
1
No. Name
1 Feed length
2 Media feeding direction
o When the initial adjustment printing is complete, the printer enters the normal status
• After the initial adjustment printing, cut the media. See “Cutting media”
Step 1 : Measure the distance between two pluses in the initial adjustment print using a measurement
tool, such as a ruler.
Step 1 : Set up Initial Adjust Change.
• Press the [+] key or [–] key to select "PF2: Init.Adj.Change".
• Press the [Enter] key on the operation panel.
o The operation panel displays "Init: 250.0/250mm".
• Press the [+] key or [–] key and enter the measured value in step 3.
• Press the [Enter] key on the operation panel
o The initial adjustment value is saved.
o The operation panel displays "PF2: Init.Adj.Change".