User`s guide

Operation Instructions VJ-1204
47
AP-77170, Rev. 2.0, 2/04/2007
Step 10 : Perform the Confirm Print.
• Press the [+] key or [–] key to select "PF3: Confirm Print".
• Press the [Enter] key on the operation panel.
o The operation panel displays "Feed Length: 250 mm".
Notes
• The length that media is fed (feeding length) for confirmation adjustment printing is normally set at 250
mm.
• If you make the feeding length longer, the accuracy of the Media feed compensation improves.
If you want to change the feeding length, press the [+] key or [–] key and change the set value.
• Press the [Enter] key on the operation panel.
o The operation panel displays "Printing".
o Start Confirmation adjustment printing.
2
1
No. Name
1 Feed length
2 Media feeding direction
• After the confirmation adjustment printing, cut the media. See “ Cutting media”
Step 1 : Measure the distance between two pluses in the confirmation adjustment print using a
measurement tool, such as a ruler. Then, confirm that the distance matches the feeding length
when printing.
• If the distance does not match the feeding length, follow the procedure from 1 to 5 and
readjust.
• If the distance matches the feeding length, proceed to step 7.