User`s guide

Operation Instructions VJ-1204
56
AP-77170, Rev. 2.0, 2/04/2007
Step 11 : Start the head cleaning.
Notes
• Pressing the [Cleaning] key again after the first head cleaning is done, performs a strong cleaning.
• If you fail to remove blurs or incompleteness of printing in one head cleaning, you should perform the
strong cleaning.
• If you fail to remove blurs or incompleteness of printing with several head cleaning, refer to
Troubleshooting, and perform the adequate process.
Notes
• If when you are cleaning, the ink level reaches its end, an ink end indication will be displayed to warn
you.
4.1.5 Cleaning the wiper
(1) Cleaning time
Once a week or when blurs or incompleteness in printing remain after head cleaning.
(2) Cleaning steps
Follow the steps below to clean the wiper.
Notes
• Use the poly-knit wiper when cleaning the wiper.
Step 1 : If the printer is switched ON, make sure that:
• Printing or other operations are not in progress.
• The display on the operation panel is in the normal state.
Step 1 : Press the [Enter] key on the operation panel.
• The printer starts cleaning the wiper.
• The operation panel displays "CR Maintenance: End".