Quick Installation Guide

e 11

To install the receiver, please follow the steps below:

5. Connect the Active VGA Balun II receiver to the

display equipment.

6. Connect the UTP cable to the Video IN/UTP

connector of the receiver.

7. If the distance exceeds MuxLab’s specified limit for

remote power, connect the second 12 VDC power

supply to the receiver and then plug the power

supply into an AC power outlet. If power is present,

then the green power LED will be ON.

8. To adjust the picture quality, toggle the gain

adjustment DIP switches on the rear panel of the

Active VGA Balun II receiver. The factory default

position is “all OFF” (up position).

1234

EQUAL GAIN

Figure 3: DIP switches for gain adjustment