Quick Installation Guide

e 13

11. DIP switch positions 1 to 3 adjust the equalization to

compensate for high frequency signal loss due to the

Cat5E/6 cable.

12. The DIP switch positions 4 to 6 adjust the luminance

level to compensate for low frequency signal loss

due to the Cat5E/6 cable.

13. The following diagram shows the final

configuration.

Figure 4: Typical Configuration – Remote Power

14. Upon boot-up, the Active VGA Balun II reads the

DDC information from the Local Monitor (if

connected) and sets the monitor size and resolution

according to the Local Monitor.

15. If the Local Monitor is not connected, the Active

VGA Balun II reads the DDC information from the

remote screen and sets the size and resolution

according to the remote screen.