Instruction Manual

© MuxLab Inc. Active VGA/Audio Balun Kit Installation Guide
P
a
g
e 13
To install the receiver, please follow the steps below:
8. Connect the Active VGA/Audio Balun receiver to
the display equipment with the appropriate VGA
video & audio cables.
9. If the Analog Audio (AA) interface is used (Stereo
3.5 mm), toggle the Audio switch to the “AA”
position. If the Digital Audio (DA) interface is used
(RCA), toggle the Audio switch to the “DA”
position.
Figure 4: Position of the Audio Switch on the receiver
10. (Optional) Connect an infrared receiver to the 3.5
mm connector.
11. (Optional) Connect the RS232 to the equipment with
the appropriate DB9 to DB9 cables. Note: If the
infrared 3.5 mm connector is plugged, the RS232
interface is disabled. Set the RS232 interface as
follows:
BAUD Rate: 9600
Data bits: 8
Stop bits: 1
Parity: None
Flow control: Hardware