Instruction Manual

e 14

12. Connect the UTP cable to the Video IN/UTP

connector of the receiver.

13. Connect the second 12 VDC power supply to the

receiver.

14. Plug the power supply into an AC power outlet. If

power is present, the green power LED will be ON.

15. The brightness rotary switch adjusts the luminance

level to compensate for low frequency signal loss

due to the Cat 5e/6 cable.

16. The sharpness potentiometer adjusts the equalization

to compensate for high frequency signal loss due to

the Cat 5e/6 cable.

17. The skew (R G B potentiometers) adjust the delay

between the red, green, and blue colors to

compensate for the delay differences due to the Cat

5e/6 cable.

18. To adjust the picture quality, rotate the brightness

rotary switch and/or sharpness and/or skew

potentiometers on the rear panel of the Active

VGA/Audio Balun receiver. The factory default

position for the brightness (“Bright”) is “None,” and

the factory default position for the sharpness

(“Sharp”) and skew (R G B) is zero (rotated

completely counterclockwise).

Figure 5: Brightness and Sharpness Adjustment