M292 Carbon Copy Deluxe Analog Delay ® With extended delay time, tap tempo functionality, and a number of other features, this pedal updates the sound and operation of the respected Carbon Copy Delay for discerning players with modern gigging and recording needs. jimdunlop.
External Controls 4 5 6 7 8 3 9 10 2 11 1 1 TAP-BEAT footswitch sets tempo of repeats (indicated by orange LED) 2 TAP DIV switch cycles through tap tempo subdivisions (indicated by LED screen) 3 BRIGHT switch accentuates high end frequencies of delay signal (red LED indicates on) 4 MIX knob controls ratio of wet to dry signal 5 REGEN knob sets number of repeats 6 DELAY knob sets delay time 7 EXP jack allows for external control of various functions 8 SPEED knob controls rate of mo
Basic Operation 1. Run a cable from your guitar to the M292’s INPUT jack and another cable from the M292’s OUTPUT jack to your amplifier. 2. Start with all controls at 12 o’clock. 3. Turn the effect on by depressing the EFFECT footswitch. 4. Rotate the REGEN knob clockwise to increase the number of repeats or counterclockwise to decrease it. 5. Rotate the MIX knob clockwise to increase the ratio of wet to dry signal or counterclockwise to decrease it.
Advanced Operation RECOMMENDED ACCESSORIES DVP3 Volume (X)™ Pedal or DVP4 Volume (X)™ Mini Pedal M199 MXR Tap Tempo Switch USING EXPRESSION PEDAL TO SWEEP BETWEEN TWO DIFFERENT SETTING CONFIGURATIONS 1. Connect expression pedal to M292’s EXP jack with a TRS cable. Expression pedal will sweep between “A” and “B” setting configurations. Previously saved settings will be automatically recalled. 2.
Advanced Operation (cont.) 8. If you haven’t saved overridden settings, you can return to previously saved settings by power cycling pedal or disconnecting the cable from EXP jack for 2 seconds and then reconnecting it. 8. If you haven’t saved overridden settings, you can return to previously saved settings by power cycling pedal or disconnecting the instrument cable from EXP jack for 2 seconds and then reconnecting it. 9.
Advanced Operation (cont.) USING A EXTERNAL TAP SWITCH TO TOGGLE MOD BUTTON ADJUSTING BRIGHTNESS OF TAP DIV DISPLAY & TAP-BEAT LED 1. Connect external tap switch to EXP jack with an instrument cable. 1. Press & hold TAP-BEAT & TAP DIV buttons while connecting M292 to power source, then release buttons after LEDs flashes. 2. Press and hold MOD button while connecting M292 to power source, then release button after MOD LED flashes. 2. Observe the flashing TAP DIV LED display brightness level.
Specifications Input Impedance 1MΩ Output Impedance 1 kΩ Maximum Output Level +8dBV Noise Floor* -96 dBV Delay Time 40ms to 1200ms Noise Reduction 2:1 ratio Modulation Speed 0.1 Hz to 10 Hz Tap Divisions Dotted 8th, 8th, Triplet, 16th Bright** 1.5 kHz, +4.5 dB 200 Hz, -3 dB Bypass True Hardwire Current Draw 22 mA*** 44 mA**** Power Supply DC 9 volts *A-weighted, MIX control Full CW, REGEN control Full CW, Internal INPUT GAIN to GTR position.
