Instruction Manual

MXR x Third Man Hardware

Double Down Pedal

MXR and Third Man Hardware have teamed up to

create the perfect booster for gigging guitar players.

The Double Down Pedal combines two separate MXR

Micro Amp circuits into a single box so that you can

dial in just the right amount of classic Micro Amp

bump for both of your signal chains.

CSP042

jimdunlop.com

™

PAGE 1
CSP042 ® MXR x Third Man Hardware Double Down Pedal ™ MXR and Third Man Hardware have teamed up to create the perfect booster for gigging guitar players. The Double Down Pedal combines two separate MXR Micro Amp circuits into a single box so that you can dial in just the right amount of classic Micro Amp bump for both of your signal chains. jimdunlop.
PAGE 2
External Controls 2 3 4 5 1 1 FOOTSWITCH toggles effect on/bypass (yellow LED indicates on) 2 GAIN 1 knob sets output level of OUT 1 signal 3 GAIN 2 knob sets output level of OUT 2 signal 4 PHASE switch selects stereophonic effect (yellow LED indicates on) 5 BUFFER switch selects true/buffered bypass (yellow-orange LED indicates buffered bypass) CSP042 | MXR® x Third Man Hardware Double Down™ Pedal 2
PAGE 3
Basic Operation Power Directions The MXR® x Third Man Hardware Double Down™ Pedal is powered by one 9-volt battery (remove bottom plate to install), a 9-volt AC adapter such as the Dunlop ECB003/ ECB003EU, or an MXR® Brick™ Series power supply. 1. Run an instrument cable from your instrument to the CSP042’s INPUT jack. Run two more instrument cables from the CSP042’s OUT 1 and OUT 2 jacks to two separate amplifiers. 2. Start with knobs set fully counterclockwise. 3.
PAGE 4
Specifications Input Impedance Buffer OFF > 450 kΩ Buffer ON > 700 kΩ Output Impedance < 1 kΩ Bypass Buffered/True Bypass Current Draw 11 mA Power Supply 9 volts DC CSP042 | MXR® x Third Man Hardware Double Down™ Pedal 4