Service manual

3.0 Maintenance Guide
17
Figure 15
4. Make sure there is a slight gap between the front hand crank and the machine, slide collars
up tight against the nylon washers and tighten the collar screws.
5. Check to make sure the hand crank turns freely with no play.
6. Lay the machine flat.
3.4.7 Line-Light Adjustment
The line-light can be adjusted if necessary as follows:
1. Lower the clamp to the table. Remove the clamp handle, cutting lever handle, and top cover.
2. Loosen the three line-light mounting screws (Figure 16, page 17).
Figure 16
Leadscrew
Collars
Line Light
Mounting
Screws