Specification Sheet

ManualsBrandsMy Cable Mart ManualsAccessories & SuppliesMyCableMart ARM 3-Way Adjustible/Tilt (18") Wall Mount Bracket 12-42" to 66 lbs Black

INSTALLATION INSTRUCTIONS

Max Load Capacity: 30kg(66lbs)

30kg

(66lbs)

MAX

Pitching angle:

-20° ~ +20°

Swivel: 180°

Model: LCD-503A

LCD Wall Mount

Maintenance

Once you have mounted the bracket and the flat screen, check that they are sufficiently secure and safe to

use. You should check whether screws are fixed well each two months. If you have any doubts regarding the

installation, please consult our retailer or service department for details.

Pitching Angle Adjustment

• Use the tilt adjusting knob to adjust your TV to the desired angle, the pitching angle can be adjusted

between -20°~20°, as shown in fig 5.1.

fig. 5.1

wall

Tilt adjusting knob

Summary of content (4 pages)

PAGE 1
3 5 Pitching Angle Adjustment • Use the tilt adjusting knob to adjust your TV to the desired angle, the pitching angle can be adjusted between -20°~20°, as shown in fig 5.1. INSTALLATION INSTRUCTIONS wall wall Tilt adjusting knob fig. 5.1 Maintenance Once you have mounted the bracket and the flat screen, check that they are sufficiently secure and safe to use. You should check whether screws are fixed well each two months.
PAGE 2
NOTE: Read the entire instruction sheet before you start installation and assembly. Component Checklist IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installing. If any parts are missing or faulty, telephone the special franchiser for a replacement. WARNING • Do not begin the installation of the product before you have read and understood the instructions and warnings contained in this installation sheet.
PAGE 3
1a 1b Wood Stud Wall Mounting: Solid Brick And Concrete Block Mounting: WARNING WARNING • Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components. • Tighten wood screws firmly, but do not over tighten. Over tightening can damage the screws, greatly reducing their holding power. • Make sure that mounting screws are anchored into the center of the studs. Use of an “edge to edge” stud finder is highly recommended.
PAGE 4
M-O Installing the Display • Find the appropriate VESA, attach the adapter plate to the back of the screen using the appropriate combination of screws, washers, as shown in fig.4.1 and fig.4.2. • Begin with the proper screw, hand thread through washer and adapter plate into screen as shown below. • Screw must make at least three full turns into mounting hole and snug fit into place. Do not over tighten. • Repeat for remaining mounting holes, level plate and tighten screws. M-N M-L M-H fig. 2.