Specification Sheet

Wood Stud Wall Mounting:

WARNING

• Make sure that the supporting surface will safely support the combined load of the

equipment and all attached hardware and components.

• Tighten wood screws firmly, but do not over tighten. Over tightening can damage

the screws, greatly reducing their holding power.

• Make sure that mounting screws are anchored into the center of the studs. Use of

an “edge to edge” stud finder is highly recommended.

• Hardware provided is for attachment of mount through standard thickness drywall

or plaster into studs. Installers are responsible to provide hardware for other types

of mounting situations.

fig. 1.1

WARNING

• When installing wall mounts on cinder block, verify that you have a minimum of

1-3/8” of actual concrete thickness in the hole to be used for the concrete anchors.

Do not drill into mortar joints! Be sure to mount in a solid part of the block,

generally 1” minimum from the side of the block. It is suggested electric drill on

slow setting is used to drill the hole instead of a hammer drill to avoid breaking out

the back of the hole when entering a void or cavity.

• Installer must verify that the supporting surface will safely support the combined

load of the equipment and all attached hardware and components.

Solid Brick And Concrete Block Mounting:

• Use the wall plate as a template to mark six holes locations on the wall, as shown in fig.1.2.

• Pre-drill these holes with a 10mm masonry bit to at least 60mm in depth. Insert a concrete anchor (W-B)

into each of these holes. Attach the wall plate to the wall using six wood screws (W-A) and six washers

(W-C), as shown in fig.1.3.

• Use a stud finder to locate the edges of the studs. Use of an edge-to-edge stud finder is highly recommended.

Based on their edges, draw a vertical line down each stud’s center.

• Place wall plate on wall as a template. And mark the center of the two mounting holes. Make sure that the

mounting holes are on the stud centerline.

• Drill two 1/8” (3mm) dia. Holes 1.2” (30mm) deep. Make sure that the wall plate is level, secure it using

two screws (W-A) and two washers(W-C) as shown in fig. 1.1.

Stud

W-A

W-C

fig. 1.2 fig. 1.3

• Assemble the adapter bracket with appropriate parts as shown in fig.2.1.

• Assemble the adapter bracket and arm of wall plate with appropriate screw, washers and nut. As shown

in fig.2.2.

Adapter Bracket Mounting

W-A

W-B

W-C