Specification Sheet

Installing the Display

• Find the appropriate VESA, attach the adapter plate to the back of the screen using the appropriate

combination of screws, washers, as shown in fig.4.1 and fig.4.2.

• Begin with the proper screw, hand thread through washer and adapter plate into screen as shown below.

• Screw must make at least three full turns into mounting hole and snug fit into place. Do not over tighten.

• Repeat for remaining mounting holes, level plate and tighten screws.

• Cut off the corner of the decorative cover for easy to the cable management and then run power cable

through the hole of decorative cover.

• Snap the decorative covers from left and right to cover the wall plate rails and the bracket arm as shown in

fig. 3.1.

Cable Management and Decorative Covers Mounting

fig. 2.1

fig. 2.2

M-L

fig. 4.1

fig. 4.2

M-C

M-D

M-G

M-H

M-A

M-B

M-I

M-E

M-F

M-J

M-M

M-K

fig. 3.1

M-N

M-H

M-O