Instruction manual

page 15

Installing for Group II [15-25kg]

Removing the seat cover

Ensure that you have rst removed the

child car seat’s integral 5-point harness,

following the steps under ‘Removing the

5-point harness’,

Position your child in the child car seat,

place the diagonal section of the

seatbelt through the diagonal seatbelt

guide (A) and the waist belt across the

child’s lap and through belt guide (B).

Finally fasten the seatbelt buckle (C).

WARNING: The child car seat should

always be buckled in and secured,

whether a child is seated in it or not!

The seat cover is a safety feature. Never

use the child car seat with out its cover.

The seat covers can be removed for

cleaning (see “Maintenance and

cleaning” p18). You will need a Phillips

screwdriver.

If not already removed then remove

the harness straps, crotch strap,

head cushion and base cushion (see

‘Converting for children in group II [15-

25kg]’ pages 11-13).

Turn the child car seat on its side and using a Phillips screwdriver, unscrew the two

screws on each side of the shell holding the belt guides (A) in place. Put the belt

guides and screws safely to one side for later.

Remove the two small side covers (B) by grasping the elastic band and pulling each

cover off.

The main cover is held in place by a series of hooks (C) located on the back and

underside of the shell. Unhook the cover’s elastic from the hooks. Work the cover from

under the strap hooks (D) and remove.