Installation Guide

★ MEASURE YOUR TABLE & UMBRELLA POLE BEFORE ORDER. ★ This umbrella
wedge might have a pre-cut seam at one side for better-fit the umbrella pole, and it
works fine inside the patio table hole.
▼ Fits umbrella pole diameter 1 1/2 inch (38mm) ; Table hole opening / umbrella weight
base hole diameter 1.8 to 2.4 inch (see images). ▼ Twist / rotate the cone wedge to fit
in table hole. ▼ Lubricating oil / soap-suds / vaseline / sanding might be helpful in
installation. ▼ No more swaying / wobbly umbrella.
▼ Curved (see engineering drawing in second images) Tapered Design keeps the
Umbrella properly seated and eliminates any rattles. ▼ Rubber Umbrella Cone Wedge
works with any table and umbrella combination, helps to keep the umbrella properly
centered over the table.
▼ Installs in seconds and is easily removed for storage. We have two sizes for
umbrella poles in diameter: 1 1/2" (38mm) or 1 3/8" (35mm). ▼ Additional 4 holes on
the top for inserting flowers, pen, or table sign. ▼ 100% Brand New & Extra
weather-resistant material used for outdoors.
★ Installation: 1. Draw out the umbrella and pole from the hole on the patio table. 2.
Install the Myard Cone Wedge onto the umbrella pole. 3. Insert the umbrella and pole
back to the hole on the patio table. 4. Spin and push the Cone Wedge downard gently
in order to have it sinked into the hole compactly. (lube / oil / vaseline might help in
doing this) 5. DONE