SDS

深圳普瑞赛思检测技术有限公司
ShenzhenPreciseTestingTec hn ol o gy Co.,LTD.
ReportNo.:S‐15020011Page5of11
5. 消防措施
Fire-fighting measures
燃点：不适用
Flash Point: N/A.
自燃温度：不适用
Auto-Ignition Temperature: N/A.
灭火介质：大量水（降温），二氧化碳
Extinguishing Media: Water, CO
2.
特殊灭火程序：自给式呼吸器
Special Fire-Fighting Procedures
Self-contained breathing apparatus.
异常火灾或爆炸：当电芯暴露于过热的环境中时，安全阀可能会打开。
Unusual Fire and Explosion Hazards
Cell may vent when subjected to excessive heat-exposing battery contents.
燃烧产生的危险物品：一氧化碳，二氧化碳，锂氧化物烟气
Hazardous Combustion Products
Carbon monoxide, carbon dioxide, lithium oxide fumes.
6. 泄露应急处理
Accidental release measures
为防止电池材料泄露或释放采取的措施
如果电池内部材料泄露，试验人员应立刻撤离试验区直到烟气消散。将通风设备打开吹散危险性气体。用抹
布擦净试验区，清除溢出的液体，将泄露电池放进塑料袋中，然后放进钢制容器。避免皮肤和眼睛接触或吸
入有害气体。
Steps to be Taken in case Material is Released or Spilled
If the battery material is released, remove personnel from area until fumes dissipate. Provide maximum
ventilation to clear out hazardous gases. Wipe it up with a cloth, and dispose of it in a plastic bag and put
into a steel can. The preferred response is to leave the area and allow the battery to cool and vapors to
dissipate. Provide maximum ventilation. Avoid skin and eye contact or inhalation of vapors. Remove spilled
liquid with absorbent and incinerate.
废弃物处置方法
建议将电池完全放电，消耗电池内部的锂金属，并且深埋于土壤中。
Waste Disposal Method
It is recommended to discharge the battery to the end, to use up the metal lithium inside the battery, and to
bury the discharged battery in soil.
7. 操作处置和储存
Handling and storage
禁止打开、毁坏或焚烧电池，因为电池有可能在这些处理过程中发生爆炸、破裂或泄露等事故。
禁止将电池短路、过充、强制放电或扔入火中。禁止挤压刺穿电池或将电池浸入溶液中。
The battery should not be opened, destroyed or incinerate, since they may leak or rupture and release to the