CCP FRIDGE·FREEZER Operation Manual for AC/DC Fridge ·Freezer Single Zone Models CCP 30 / 36 / 44 / 60 / 73 / 105 Dual Zone Models CCP 69 / 85 / 96 www.mycoolman.com.
CCP FRIDGE·FREEZER Contents Important Safety Warnings Important Product Information Product Features LED Control Panel & Operation Instructions Bluetooth Mode Instructions Two Way Opening and Removable Lid Emergency Override Cleaning & Maintenance Troubleshooting Status Indicator Notes Product Specifications Warranty Terms & Conditions page page page page page page page page page page page page page 2 3 3 4-5 6 7 8 8 9 10 11 12 12 Important Safety Warnings • DO NOT use if any of the electrical cables
CCP FRIDGE·FREEZER Important Product Information • Best performance is achieved in ambient temperatures between +10 °C and + 43 °C. • Temperatures above +32 °C may see a slight performance drop, and power consumption increase. • The lower the ambient temperature, the lower the power usage. In order to maximize efficiency, keep the unit in a cool location out of direct sunlight.
CCP FRIDGE·FREEZER LED Control Panel & Operation Instructions Control Panel Single Zone (CCP 30 / 36 / 44 / 60 / 73 & 105) Power Switch Turbo Switch Power/Status Indicator Light LED-Display Control Panel Dual Zone (CCP 69 / 85 & 96) Power Switch Mode Temperature Settings Turbo Indicator Light Power/Status Indicator Light LED-Displays Turbo Switch Switch Compartments / Mode Temperature Settings Turbo Indicator Light NOTE: Temperature can be set from –22 ºC to +10 ºC in each compartment Turning
CCP FRIDGE·FREEZER LED Control Panel & Operation Instructions Engaging Turbo mode: What is the purpose of Turbo Mode? It enables the compressor to run at a higher speed, therefore achieving faster cooling to your nominated temperature. Step 1: Press the button once to turn on. The light will illuminate green to indicate that Turbo Mode is engaged. Step 2: To turn off, press the button again. The green light will now go out to indicate that Turbo mode is no longer engaged.
CCP FRIDGE·FREEZER Bluetooth Mode Instructions Activate Bluetooth mode: Step 1: Press the Step 2: Use the and and button for 3 seconds together at the same time button to choose either CLO (closed) or OPE (open). Step 3: Once you reach your desired setting you do not need to press any further buttons. Just leave it sit until you see the setting flash 5 times – this means the setting is now locked in NOTE: • CLO: Bluetooth mode is off.
CCP FRIDGE·FREEZER Two Way Opening and Removable Lid Purpose for removing the lid: CCP 30, 36 & 44 – This lid can be removed for cleaning. CCP 60, 69, 73, 85, 96, 105 – This lid can be removed to aid with cleaning and to change the opening direction. You can change the direction of the lid by following the below instructions. How to remove the lid: Open the lid fully, then overextend, pushing lid past this point to remove.
CCP FRIDGE·FREEZER Emergency Override Fuse 6.3A The Emergency Override Switch is located just below the main control panel next to the power inlets For normal operation the switch is in the “NORMAL USE” position. If the electronics in the display board fail or controls become non-functional, slide the switch to EMERGENCY OVERRIDE position. NOTE: • In EMERGENCY OVERRIDE, the cooler runs with full cooling capacity (i.e.
CCP FRIDGE·FREEZER Troubleshooting How to get the most out of your unit: • Best performance is achieved at ambient temperatures between +10 °C and +32 °C. • Product is rated as a ‘T Climate’ class (Tropical), which means that the units meet the requirements of ISO-15502 at 43 °C. • Higher ambient temperatures mean that the compressor will run faster and longer. • If the unit is in direct sun, this also increases the ambient temperature and may result in the compressor running faster and longer.
CCP FRIDGE·FREEZER Status Indicator E0 flash every 4 seconds temperature sensor issue: • Contact Leisure-Tec on 1300 07 2018 E1 flash every 4 seconds - low voltage & Battery Protection: • An E1 will occur when the battery protection level has been reached. i.e input voltage to low for protection setting, check power source voltage. • Try on different power source (vehicle or 240V AC power). If changing power source fixed issue, then possible issue with original power source.
CCP FRIDGE·FREEZER Notes: page 11
CCP FRIDGE·FREEZER Product Specifications Model CCP 30 CCP 36 CCP 44 CCP 60 CCP 73 CCP 105 CCP 69 CCP 85 CCP 96 Single Zone Single Zone Single Zone Single Zone Single Zone Single Zone Dual Zone Dual Zone Dual Zone Length 610 Length 652 Length 652 Length 732 Length 732 Length 912 Length 732 Length 912 Length 912 Dimensions Width 340 Width 412 Width 412 Width 456 Width 456 Width 536 Width 456 Width 536 Width 536 mm Height 424 Height 428 Height 488 Height 488 Height 555 Height 500 Height 555 Height 470 Hei
