Installation & Assembly
Installation
There are eight (8) points of contact where MyCube’s interior allows screws to secure the safe to a wall
and oor/shelf. Four (4) points are on the bottom, and four (4) points are on the back of each safe.
Decide on a position for your safe that will allow you to secure it to surfaces behind and/or beneath the
safe (wall, oor/shelf). We recommend securing both the bottom and the back, if possible.* When the
safe is in the desired position, take a marker and through the pre-drilled holes inside the safe, mark the
surface(s) behind or under the safe into which you will be securing the screws.
Remove the safe and note where on the mounting surface you have marked the holes. Use a power drill
and drill into each mark you have made on the surface(s) to make holes for the provided screws.
Put the safe back in position, taking care to line up each hole in the safe over each of the drilled points.
Place each of the provided washers over each hole in the safe, and with a screwdriver, secure each pro-
vided screw into the oor, the wall or the shelf mounting surfaces until the screwdriver can no longer be
turned by hand.
*MyCube Safe is designed to discourage and deter theft and to create secure storage for your valuable papers and the things
you treasure. No installation is foolproof, of course, but we strongly suggest securing MyCube to two strong surfaces.
MY SAFE FOR MY STUFF
mycubesafe.com | @mycubesafe