FIRE SAFE USER MANUAL
Safety Precautions Safety precautions are to prevent any unexpected risk or damage. Please read before use. · Be careful when opening and closing door. Finger or objects may get stuck. ·Keep away from children. ·Do not hit edge of safe to avoid injury. · Safe is heavy. be careful when moving or installing safe to avoid any injury. · Firmly fix safe to ground when installing. When moving safe, inquire a professional if needed. ·Improper handling of safe can cause damage to floor or table.
Keypad Overview Handle Display Screen Keypad Green/Red Light Battery Cover Battery Cover Hook Handle Display Keypad Screen Start button Start button Key Hook Hook Keypad Lock Mode 1. Press START for more than 3 seconds until “Act” appears. “Act” message signifies activation of keypad lock mode. Any keypad input will only display “Act.” 2. To deactivate keypad lock mode, press START for more than 3 seconds until “dEAct” appears.
Replacing Batteries Replace batteries immediately when •screen displays “Lo_bAt.” • safe door fails to open when “OPEn” message appears after password is entered. • “good” appears on display along with “beep beep” sound after password is entered. •screen fails to turn on after you press START button. How To Replace Batteries ① Remove battery cover. ② Insert batteries. ③ Put battery cover back in until a click is heard.
Opening / Closing Door 1 Press START button. •“------” will be displayed on screen. 2 Input six-digit password. •Input factory password "1,2,3,4,5,6". "OPEn" will be displayed on screen along with beep sound. • • • • • Press START button twice for security mode to hide password. Press START button to cancel password entry. Safe must be opened within 3-4 seconds "Err-03" indicates incorrect password. 5consecutive incorrect passwords will sound alarm for 3 minutes.
Changing Password Attention Safe can be programmed with either 1 or 2 passwords. 1 Enter current password and open door. 2 Press white memory button located inside door. •“-CodE-“ will be displayed, then “USEr_” will be displayed. 3 Press 1 then START button. •“------” will be displayed. 4 Enter new 6-digit password. •“AgAin” , then “------” will be displayed. 5 Enter new password again. •“In 1” will be displayed. 6 New password is set. •Confirm new password works with door open.
Trouble-shooting Situation No response when START button pressed Alarm continues ringing and safe does not work "Err-03" message appears Green light ON, does not open when "OPEN" is displayed Cannot change password “Lo_bAt” message appears “Act” message appears Possible Cause Measures l Dead battery l Replace new batteries l Incorrect insertion of batteries l Confirm correct insertion of batteries Keypad lock mode ON l Press START for 3 seconds to deactivate keypad lock mode l Circuit error l
Anchoring Instructions (Only for safes with pre-drilled anchor holes) Notice : A nchor bolt must be inserted into floor BEFORE safe is bolted down. 1. Anchor bolts vary according to model. After checking anchor bolt size, drill a hole to a depth of 2 inches (50mm). Refer to chart for appropriate hole size. A(Anchor size) B(Diameter of hole) 1/4"(M6×50mm) Ø10(5/16") 3/8"(M10×101mm) Ø14(9/16") 3/8"(M10×152mm) Ø14(9/16") 2. Insert anchor bolt and pipe into hole. 3.
