User Manual

4
2: Installation of the detection loop
To install the TnetX Pro system, one needs to install one
or more detection loops, connect the host and mount the
communicator to the car/motorcycle. For optimal results,
please follow the instructions as described carefully. Appendix
B contains a list of useful tools for installing the detection
loop.
2.1 Positioning
All wiring of the detection loop must be installed according to
the drawing below in order to avoid a serious degradation in
the performance of the system.
Figure 2.1 Detection loop installation overview
Trackwidth
20 m
Trackwidth
10 m
Max 10m
(33 ft)
60 cm (2 ft)
Max 10m
(33 ft)
3 mm (1/8")
15 - 20 mm (5/8" - 3/4")
R=Termination box (470 Ohm, 0,25 Watt resistor)
10 cm
(4")
max. 60 cm (2ft)
max.
120 cm
(4 ft)