Installation Guide

11 www.mylenstairs.com
Tread and Baluster Installation
1. Start installation with the top tread. Place a main baluster (3) in the hole
closest to the platform. Move the baluster up or down until the bottom of
the baluster is flush with the bottom edge of the tread.
2. Attach this baluster to the tread using the carriage bolt (G), nut (F), washer
(D) and lock washer (E).
NOTE: Main Balusters have two holes drilled near the bottom.
3. For stairs that are 60” in diameter, plumb the main baluster and attach to
the face of the platform using the top baluster bracket, carriage bolts (H)
and SQ Drive D&T screws (I), nut (F), washer (D), and lock washer (E). For
stairs that are 42” in diameter, plumb the main baluster and attach to the
face of the platform using carriage bolt (G), nut (F), washer (D) and lock
washer (E). A ¼” diameter hole must be drilled in the platform at the
location of the pre-drilled hole in the baluster.
4. Check that the tread is level and the baluster is plumb. Tighten the 5/16”
set screws in the tread hub to lock the top tread to the center column.
Hardware
ⒹⒺⒻⒼ
ⒽⒾ
Parts
③
Tools