Installation Guide

15 www.mylenstairs.com
7. Repeat steps 5 and 6 until the cut end is vertical. It should now be long
enough to form by hand.
8. Hold the coil in place and pull the unsecured side outward and away
from the center of the coil until the coil bends slightly. It may be
necessary to brace the coil where it contacts the ground to prevent it
from slipping while forming.
9. Continue rotating the coil and forming until the whole coil has been
worked through. Measure the coil diameter to determine if more
adjustment is needed. If so, repeat the forming process from the
beginning.
IMPORTANT: Do not try to bend the handrail into shape on the first pass
through the coil. For best results, make small adjustments and repeat the
process as needed.