Installation Guide

20 www.mylenstairs.com
3. Insert bolt (S) through the tread and into hex nut (F). Do not fully tighten
the hex nut.
4. Thread a tube connector (T) onto the exposed threads of the bolt until it is
seated against the hex nut. Make sure the flanges on the tube connector
are facing down towards the tread surface. Unscrew the tube connector
one revolution to create a gap between the nut and the tube connector.
5. Ensure that the baluster tip is in line with the handrail, then slide the center
baluster onto the tube connector.
6. Install screw (R) through the hole in the tip of each center baluster.
7. Tighten the screw that was installed in step 3. This will pull the baluster
against the tread and complete the connection.
8. Repeat steps 1-7 for each center baluster.