Installation Guide

28 www.mylenstairs.com
Wood Tread Cover Installation
17. The treads are not pre-drilled to accept the tread covers (1).
18. Drill four ¼” holes in the steel tread top in the approximate location shown
below. Do not drill the holes too close to the edge of the tread top. If the
holes are too close to the edge of the tread, the wood tread cover could
split when installing the screws.
19. Locate the wood tread cover on top of the tread and center it so the
reveal is the same on the front and back of the tread.
20. Install the pan head wood screw (A) through the holes drilled in step 2 and
into the wood tread cover.
21. Repeat this step for each tread until all the tread covers have been
installed.
Hardware
Ⓐ
Parts
①
Tools