Installation Guide

I. Press any mortar that has been forced out back

into the joints using a polyfoam brush.

J. Remove all mortar from the glass block faces.

7. Finishing

Note: Allow the mortar to set up for about one hour

before proceeding.

Note: To prevent scratching of the glass DO NOT use

abrasive materials for this cleanup.

A. Twist off the spacer tabs on both sides of the panel.

B. With moderate pressure, run the striking tool over

all the joints. It is best to strike all the horizontal

 MRLQWVÀUVWWKHQWKHYHUWLFDOMRLQWVVRWKHSDWWHUQLV

uniform. Fill any voids with mortar.

Note: Striking removes excess mortar and compacts

the joint to create a smooth, concave, moisture-proof seal.

C. Use a damp sponge to remove the excess mortar

from the block face, rinsing the sponge frequently.

 'RQRWEHFRQFHUQHGDERXWWKHGU\ÀOPWKDW

remains on the blocks, it will be cleaned off later.

Note: Allow the mortar to dry for about two to three hours

before proceeding.