Users Manual

SENSE MCE IBC Operating Instruction

Rev. D, 2020-12-15 Release Page 13 of 46

1.9 Certification / Compliance

1.9.1 FCC

The MYNXG Sense MCE IBC is FCC certified. This device complies with part 15 of the FCC

Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and

2. this device must accept any interference received, including interference that may

cause undesired operation.

IMPORTAN T N OTICE

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful.

interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is

likely to cause harmful interference in which case the user will be required

to correct the interference at his own expense.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one of the following measures:

▪ § Reorient or relocate the receiving antenna.

▪ § Increase the separation between the equipment and receiver.

▪ § Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

▪ § Consult the dealer or an experienced radio/TV technician for help.