Operation Manual

MyotonPRO User Manual
Page 45 of 108
7.2 Non-standardized choices (Location, State
and Accel. Graph
27
) in the Profiles section
are activated by clicking on Advanced.
8. Select the Objects for the Pattern by either
double clicking or highlighting and then
clicking on the right arrow button above
the list of Objects.
It is possible to select a maximum of 50
Objects for the Pattern.
9. The order in which measurements are
taken can be changed to minimise
disruption to the Subject. This can be done
in the section Selected Profiles by pointing
on the Tissue and clicking on either Up or
Down buttons.
10. To change the values of the mechanical
impulse of the Device (Tap time and
Interval)
28
that are assigned to the
Measurement profile in the default set-up,
first activate Advanced (see point 7.2) and
then perform changes in the corresponding
columns in the section Selected Profiles.
27
The choice Accel.Graph saves an acceleration signal that consists of 1280 numerical values for every measurement
result. To spare the memory of the Device and computer, it is advisable to not activate the choice Accel. Graph, if not
needed.
28
“Tap time” and “Interval” are explained in the chapter “Terminology“.