Operation Manual

MyotonPRO User Manual
Page 55 of 108
3.5.3 Entering new Subjects
It is possible to enter new Subjects in the Device for performing measurements.
COMMENT It is recommended to always use Computer Software for the insertion of New Subjects as a part of
the standard Measurement Set creation process (see chapter 3.4.1). In special cases, the new
Subjects can also be created by using the Device.
Should these newly created Subjects be used for the conduction of measurements, then all the
Subjects' data (see chapter 3.4.1) have to be filled in separately during the downloading the
measurement results to the Computer Software (see chapter 3.6.1, point 3.2). To match the
right Subjects with the right profile data, it is important to remember or write down the unique
identification numbers shown for each Subject in the Device.
Description of the action
Screen shot
1. Click on Measurements on the initial screen of the Device (or
on the ON/NEXT button of the Device).
2. To enter a new Subject in the Device, click on Add new
subject and confirm the selection by clicking on Yes.