Owner manual
stream of the solution you intend to measure by allowing the
at least 10 seconds.
.
6. Take reading. Annunciators alert you when the concentration is
-Or-
MS to store reading in memory if desired.
IMPORTANT:
VI. SOLUTION SELECTION
A. Why Solution Selection is Available
Conductivity, resistivity, and TDS require temperature correction to
the temperature correction of conductivity and calculation of TDS from
B. The 4 Solution Types
On the left side of the display is the salt solution characteristic used to
model temperature compensation of conductivity and its TDS conversion.
standardization. This is how your instrument is shipped from the factory
The User selection allows a custom value to be entered for the
temperature compensation of conductivity and also the conversion ratio
if measuring TDS.
C. Calibration of Each Solution Type
There is a separate calibration for each of the 4 solution types. Note