Owner manual

13
D. Procedure to Select a Solution
NOTE:

1. Press , or to select the parameter on which
you wish to change the solution type.
  key
Figure 1
KCl
442
NaCl
User
for 3 seconds to make “SEL”
 
demonstration purposes, all
4 solution types are shown
simultaneously.
3. Use the or key to select type of solution desired
 
 
4. Press to accept new solution type.
E. Application of User Solution Type
1. User Programmable Temperature Compensation

This feature allows you to change your Ultrameter II’s temperature
       


a. As in D. Procedure to Select a Solution above, select “User”
mode.
b. With User mode now selected, press 
 
by pressing or .
 
c. Press twice to skip
Figure 2
°C% /
User
COND
calibration adjustment and
 
 
are now ready to measure samples with your new temperature
compensation factor.