Owner manual


4. Press to enter calibration mode. The “CAL”, “BUFFER”
and “7
Displayed value will be the uncalibrated sensor.
NOTES: 7” and “BUFFER”
II will not adjust.



is defective and needs to be replaced .
  or 
NOTE:
cause “FAC” to appear. This indicates the need for sensor replacement
The “FAC”
internal electronic calibration is not intended to replace calibration with
        Each “FAC” indicates a

 to accept the preset factory value, or you may
reduce your variation from factory setting by pressing or .
6. Press 
 
exit by pressing any measurement key.
b. 
IMPORTANT: Always calibrate or verify your Ultrameter II
buffer solution before adjusting the gain with acid or base buffers, i.e.,

point “Gain” calibration and then the opposite for the 3rd point. The
display will verify that a buffer is in the sensor well by displaying either
“Acd” or “bAS”.
 
 

 CAL”, “BUFFER” and “Acd” or “bAS”
 