Owner manual


Figure 7
BUFFER
pH
CAL
Figure 8
pH
BUFFER
CAL
NOTE:Acd” and “bAS” indicators are blinking, the unit is indicating
an error and needs either an acid or base solution present in the sensor
well .
 
 
  or until display agrees with buffer value.
6. Press 
display indicates the next type of buffer to be used.


Exiting causes the value accepted for the buffer to be used for both acid
and base measurements.
To continue with 3rd point calibration, use basic buffer if acidic buffer


 
  to accept 3rd point of calibration, which
completes the Calibration procedure. Fill sensor well with
Myron L Storage Solution and replace protective cap.
6. 
         
reference electrode. For this reason, and because calibration solutions
II
          

  Temperature Calibration
Temperature calibration is not necessary in the Ultrameter II.