Owner manual
XVII. CARE and MAINTENANCE
Ultrameter IIs should be rinsed with clean water after use. Solvents should
be avoided. Shock damage from a fall may cause instrument failure.
A. Temperature Extremes
Ultrameter II
be exercised not to exceed rated operating temperature.
Leaving the Ultrameter II in a vehicle or storage shed on a hot day
This will void the
warranty.
B.
Dry Instrument THOROUGHLY.
Open instrument carefully. Carefully detach battery from circuit board.
screws, tighten evenly and securely.
NOTE:
memory and all calibration settings are protected even during power
C.
serial number of your instrument to ensure receipt of the proper type.
Complete installation instructions are provided with each replacement
sensor.
D. Cleaning Sensors
1.
The conductivity cell cup should be kept as clean as possible. Flushing
with clean water following use will prevent buildup on electrodes.
electrodes, use isopropyl alcohol or a foaming non-abrasive household
II is again ready for
accurate measurements.
II
combination type that features a porous liquid junction.