Manual


UP or DOWN Keys
While measuring in any parameter, the or keys activate

While in “CAL” mode, the keys step or scroll the displayed value up or
down. A single press steps the display and holding either key scrolls the
value rapidly.


IV. AFTER USING THE ULTRAMETER II
A. Maintenance of the Conductivity Cell



this does not affect the accuracy; leave it alone.
B. 
The sensor well must be kept wet with a saline solution. Before replacing
  
Storage Solution. If unavailable, use an almost saturated KCl solution,
             
        USE
.
V. SPECIFIC RECOMMENDED MEASURING
PROCEDURES
            
Solution Selection, pg. 11.
NOTE: After sampling high concentration solutions or temperature
extremes, more rinsing may be required. When sampling low conductivity
solutions, be sure the pH cap is well seated so that no solution washes
into the conductivity cell from around the pH cap.
A. 
 
 
 
  or .
4. Take reading. A display of [- - - -] indicates an overrange condition.