Owner's manual

ManualsBrandsMyron L ManualsSensors729II

INSTALLATION • OPERATION • MAINTENANCE

Conductivity/TDS Models: 756II, 757II, 758II & 759II

Resistivity Models: 751II, 752II, 753II & 754II

750 Series II

CONDUCTIVITY/TDS

RESISTIVITY

MONITOR/CONTROLLER

Operation

Manual

22 October 08

ACCURACY • RELIABILITY • SIMPLICITY

Water Quality Instrumentation

Accuracy • Reliability • Simplicity

Summary of content (5 pages)

PAGE 1
750 Series II CONDUCTIVITY/TDS & RESISTIVITY MONITOR/CONTROLLER Operation Manual 22 October 08 INSTALLATION • OPERATION • MAINTENANCE Conductivity/TDS Models: 756II, 757II, 758II & 759II Resistivity Models: 751II, 752II, 753II & 754II ACCURACY • RELIABILITY • SIMPLICITY Water Quality Instrumentation Accuracy • Reliability • Simplicity
PAGE 2
MICROSIEMENS / CM 750II HIGH SET POINT LOW 750 Series II Model 758 II -121-SC (A Digital Conductivity Monitor/controller, with a Range of 0-2000 µS, and a Second Alarm/control, Displaying Full Scale)
PAGE 3
750 Series II MONITOR/CONTROLLER QUICK REFERENCE GUIDE If you read nothing else in this manual please read this Quick Reference Guide. REASSEMBLY 1. Carefully reinstall the front panel, bottom first. Ensure no wires have been pinched between enclosure and front panel. 2. Reinstall the four (4) screws and tighten. 3. To operate, turn power ON. PLEASE READ and COMPREHEND ALL WARNINGS, CAUTIONS and ADVISEMENTS CONTAINED WITHIN THIS MANUAL.
PAGE 4
connected to an appropriate Sensor, and that the Sensor is immersed in water within the range that the Monitor/controller will be required to read; and the front panel is removed. 1. Make a note of the reading on the display. 2. While pressing the Calibration/Full Scale Test Switch (FSSW), verify that the front panel display is indicating a full scale reading. If not, see Calibration, section V.C. 3. Press and hold the “SET POINT” switch on the front panel.
PAGE 5
VIII. WARRANTY All Myron L Company Conductivity/TDS and Resistivity Monitor/controllers have a TWO Year Limited Warranty. If any Monitor/controller or sensor fails to function normally, return the faulty unit to the factory prepaid. If, in the opinion of the factory, failure was due to materials or workmanship, repair or replacement will be made without charge. A reasonable service charge will be made for diagnosis or repairs due to normal wear, abuse or tampering.