User guide

ManualsBrandsMyron L ManualsToolsPT1

4 5

ULTRAPEN

™

PT1

Conductivity/TDS/Salinity

& Temperature Pen

ACCURATE

RELIABLE

SIMPLE

PACKAGE CONTENTS:

PT1 Pocket Tester Pen - battery installed•

Scoop•

Pocket Clip•

Holster•

Lanyard•

Operating Instructions•

Professional Water Analysis

•

Accuracy of ±1% of READING

•

±.2% at Calibration Point

•

Reliable Repeatable Results

•

KCl, NaCl and 442

™ Natural Water

Modes

•

Automatic Temperature Compensation

•

Autoranging

•

Waterproof

•

(included)

Visit our we bs ite:

myronl.com/pt1.htm

myronl.com

MADE IN USAMADE IN USA

ULTRAPEN™ PT2

pH & Temperature

ULTRAPEN™ PT3

ORP & Temperature

ULTRAPEN™ PT4

Free Chlorine Equivalent

(FC

)

& Temperature

ORIGINAL

EDITED FOR USE

Minimum height 5 mm

Summary of content (6 pages)

PAGE 1
ULTRAPEN ™ PT1 Conductivity/TDS/Salinity & Temperature Pen ORIGINAL EDITED FOR USE Minimum height 5 mm S ACCURATE S RELIABLE S SIMPLE Professional Water Analysis • Accuracy of ±1% of READING • ±.
PAGE 2
INTRODUCTION Thank you for purchasing the Myron L ULTRAPEN™ PT1 Conductivity/ TDS/Salinity Pen. This instrument is designed to be extremely accurate, fast and simple to use in diverse water quality applications.
PAGE 3
Specifications Measurement Range: Accuracy (After Wet Calibration): Repeatability: Resolution: ORIGINAL Time to Reading Stabilization: Active Mode Power Consumption: Sleep Mode Power Consumption: Temperature Measurement Range: Temperature Accuracy Displayed: Temperature Compensation Method: Physical Dimensions: Weight: Case Material: Battery Type: Battery Voltage: Calibration Solution Point: Operating/Storage Temperature: Water Resistance: EDITED FOR USE Minimum height 5 mm EN61236-1: 2006 - Annex A:
PAGE 4
II. Temperature Unit Selection The PT1 allows you to select the type of units used for temperature measurements. The following table lists preference options with their corresponding units. Mode Unit Preference F Degrees Fahrenheit C ESC Degrees Celsius This is the escape function. Selecting escape exits temperature unit selection without saving changes and turns the PT1 off. To set the preference: 1. Press and release the push button.
PAGE 5
IV. Calibration The PT1 is designed to be very reliable and requires only infrequent calibration. The Myron L Company recommends calibrating each measurement mode you use once monthly. However, you should check the calibration whenever measurements are not as expected. The PT1 is programmed for 2 calibration options: Wet Calibration or Factory Calibration. Wet calibration is most accurate.
PAGE 6
Quick REFERENCE Instructions 1. Press and release push button to turn pen on. 2. While the LED flashes rapidly, dip the pen in sample solution so that the cell is completely submerged. 3. While LED flashes slowly, swirl pen around to remove bubbles, keeping cell submerged. Avoid contact with sides/bottom of container, if applicable. 4. When LED turns on solid, remove pen from solution. Display will alternate between measurement and temperature readings. 5. Note readings for your records. MAINTENANCE I.