Specifications

TYPICAL SERPENTINE INSTALLATION
UFH Circuit Return
UFH Circuit Flow
TYPICAL PIPE LAYOUT DETAIL 4
"SINGLE SERPENTINE / SINGLE MEANDER" PATTERN
Installation Notes
- Pipe normally laid in floor at 200mm
centres.
- Uses only 180° bends
which requires min 175mm
bending radius must be observed
to minimise mechanical stress on tube.
- Suitable for any shape / area.
- Suitable for battened / screed floors
- Heat output is concentrated in part of area.
- Perimeter zones difficult to achieve
if specified.
Higher output
area
Horton Rd, West Drayton, Middlesex UBL 8JL
Tel. [phone] Fax. [phone]
www.speedfit.co.uk
Technical Helpdesk 01895 425333
Issue 2 – FEB 07
SHEET 6