Installation Instructions

iVECTOR Heater/Cooler

14.0 Maintenance

Disconnect from the power supply before carrying out maintenance work.

Maintenance should be restricted to occasional removal of dust

and lint around the unit. The outer surface may be wiped over

with warm water and mild detergent taking care to avoid water

entering the grille areas.

Replacing the Filter

Periodically the filter will need to be cleaned, and the control

system on this product will display ‘FILT’ when it is time for the

filter to be checked. To remove the ‘FILT’ display, press and hold

UP for 5 seconds. Filters can be easily removed for cleaning as

shown below. See spare parts list section if replacement filters

are needed.

Remove the old filter Place the new filter

15.0 Accessories

Condensate Pump Kit 230V Condensate pump kit including

mounting brackets, float switch, and 2m

flexible tube for condensate removal

iVPUMP

Accessories

Description Technical Information Part No

iVECTOR HEATER/COOLER

INSTALLATION, OPERATING, MAINTENANCE & AFTER SALES MANUAL